Metra Electronics Automobile Accessories 99 7581 User Manual

INSTALLATION INSTRUCTIONS FOR PART 99-7581  
APPLICATIONS  
Nissan  
Frontier 2005-2008  
Frontier (XE & SE w/ No Options) 2009  
Pathfinder 2005-2007 / 2008-2010 (S models only)  
Xterra 2005-2008 / 2009-2010 (X models only)  
Suzuki  
Equator Extended Cab 2009-2010  
99-7581  
KIT FEATURES  
• DIN Head unit provisions with pocket  
• ISO DIN Head unit provision with pocket  
• Double DIN Head unit provision  
• Stacked ISO Mounts Unit Provision  
KIT COMPONENTS  
A) Radio Housing • B) ISO Brackets • C) Trim Plate • D) Double DIN Trim Plate  
Harness & Antenna Adapter (sold separately)  
• 70-7550 - 95-up Harness  
• 70-7551 - Nissan Amp Integration Harness 95-up  
• 40-NI10 - Nissan Antenna Adapter 05-09  
B
A
C
D
TOOLS REQUIRED:  
T20 Torx Driver • Small Flat Blade Screwdriver • Phillips Screwdriver  
1-800-221-0932  
© COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION REV. 05-04-10  
 
99-7581  
PATHFINDER 2005-2007/08-10 (s models)  
NOTE:  
A
Do not cycle the key while the dash is  
removed or the air bag light will come on.  
1
Disconnect the negative battery  
terminal to prevent an accidental  
short circuit.  
Unclip and remove trim panel from  
around cup holders in the center  
console. (Figure A)  
2
3
B
Unclip and remove shifter trim panel  
including pocket below radio and a/c  
controls. (Figure B)  
Unclip and remove panel at top of  
radio and remove (1) Phillips screw  
underneath. (Figure C)  
4
5
6
C
Unclip and remove entire trim panel  
surrounding radio and including a/c  
controls. (Figure D)  
Remove (4) Phillips screws securing  
radio to remove. (Figure E)  
E
D
1
 
99-7581  
FRONTIER/XTERRA 2005-2008/  
FRONTIER 2009-2010 (XE & SE w/ no options)  
NOTE:  
A
Do not cycle the key while the dash is  
removed or the air bag light will come on.  
Disconnect the negative battery  
terminal to prevent an accidental  
short circuit.  
1
2
B
Unclip and remove panel at top of  
radio and remove (1) Phillips screw  
underneath. (Figure A)  
Unclip and remove entire trim panel  
surrounding radio and including a/c  
controls. (Figure B)  
3
4
C
Remove (4) Phillips screws securing  
radio to remove. (Figure C)  
2
 
99-7581  
DIN HEAD UNIT PROVISIONS  
A
Slide the DIN cage into the radio  
housing and secure by bending the  
metal locking tabs down. (Figure A)  
1
2
Slide the aftermarket head unit into  
the cage and secure. (Figure B)  
B
3
 
99-7581  
ISO DIN HEAD UNIT PROVISIONS  
A
Mount the ISO brackets to the head  
unit with the screws supplied with  
the unit. (Figure A)  
1
2
3
Slide the head unit into the radio  
opening until the side clips engage.  
(Figure B)  
B
Snap the trim plate into the radio  
housing. (Figure B)  
4
 
99-7581  
DOUBLE DIN HEAD UNIT/STACKED ISO  
MOUNT UNITS PROVISIONS  
A
Mount the factory brackets onto the  
aftermarket radio or stacked ISO  
units using the hardware supplied  
with the new radio.  
1
Remove the (2) T-20 Torx screws  
from the factory a/c vents in the  
factory radio trim panel that will  
secure the DDIN trim plate. (Figure A)  
2
3
Secure the DDIN trim plate to the  
factory radio trim panel using the (2)  
T20 Torx screws removed in step 2.  
5
 
FINAL ASSEMBLY  
99-7581  
FINAL ASSEMBLY  
Locate the factory wiring harness in the dash and make the connection as shown.  
Metra recomends using the proper mating adapter and making the connections as  
shown. (Isolate and individually tape off the ends of any unused wires to prevent  
electrical short circuit.)  
1
Re-connect the negative battery terminal and test the unit for proper operation.  
Reassemble radio and dash assemblies in reverse order of disassembly.  
2
3
FINAL WIRING CONNECTIONS  
Make wiring connections using the EIA color code chart shown below and the instructions included with the head  
unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and individually  
tape off ends of any unused wires to prevent electrical short circuit.  
A
A)  
B)  
C)  
D)  
Strip wire ends back 1/2"  
Twist ends together  
Solder  
B
C
Tape  
D
METRA / EIA WIRING CODE  
12V Ignition / Acc. . . . . . Red  
Right Front (+) . . . . . . . . Gray  
12V Batt / Memory. . . . . Yellow  
Ground. . . . . . . . . . . . . . Black*  
Power Antenna. . . . . . . . Blue  
Right Front (-). . . . . . . . . Gray / Black  
Left Front (+) . . . . . . . . . White  
Left Front (-). . . . . . . . . . White / Black  
Right Rear (+) . . . . . . . . Violet  
Amp Turn-On . . . . . . . . . Blue / White  
Amp Ground. . . . . . . . . . Black / White  
Illumination . . . . . . . . . . Orange  
Dimmer . . . . . . . . . . . . . Orange / White  
Right Rear (-) . . . . . . . . . Violet / Black  
Left Rear (+) . . . . . . . . . Green  
Left Rear (-) . . . . . . . . . . Green / Black  
*NOTE: When Black a wire is not present, ground radio to vehicle chassis.  
All colors may not be present on all leads due to manufacturer’s specifications.  
1-800-221-0932  
REV. 05/04/10 © COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION INST95-7581  
6
 

Krups Coffeemaker Art 874 User Manual
Lenmar Enterprises Automobile Accessories MSC1LX User Manual
LG Electronics DVD Player GSA 4082B User Manual
Logitech Computer Keyboard diNovo User Manual
Lowrance electronic Radar Detector RIM 300 User Manual
Marantz CD Player CD7300 User Manual
Mazda Automobile 2011 2 User Manual
Mellerware Toaster 24404 User Manual
Memorex MP3 Player MP3838 User Manual
Miele Appliance Trim Kit DAR 1120 User Manual