KIT FEATURES
5
Various
mounting depth
alternatives
Fig. A
99-4700
INSTALLATION
INSTRUCTIONS
KIT COMPONENTS
Radio Housing
g. B
APPLICATIONS
2-SHAFT HEAD UNITS: Slide the aftermarket head unit into the kit and secure with shaft
nuts. (seeFig. A)
GENERAL MOTORS 1982-02
DIN HEAD UNITS: Cut and remove the shaft supports from the Extension Housing. Slide
the DIN cage into the kit and secure by bending the metal locking tabs down. Slide the
aftermarket head unit into the cage until secure. (see Fig. B)
VEHICLES EQUIPPED WITH J-2000 PANEL-STYLE
FACTORY HEAD UNIT PROVISIONS
(SEE INSIDE FOR SPECIFIC APPLICATIONS)
Extension Housing
Spacers
6
7
A
B
(6) Keps Nuts
C
(6) Carriage Bolts
D
A) Strip wire ends back ½"
B) Twist ends together
C) Solder
TOOLS REQUIRED
Phillips screwdriver
Cutting tool
D) Tape
Re-connect the battery terminal and test the unit
for proper operation. Mount the head unit/kit
assembly to the sub-dash with those screws
previouslyremoved.
Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adaptor and making
connections as shown. (Isolate and
individually tape off the ends of any
unused wires to prevent electrical short
circuit).
© COPYRIGHT 2001 METRA ELECTRONICS CORPORATION
Adjustable wrench
rev. 200202
3
|