Metra Electronics Automobile Accessories 99 3301 User Manual

KIT FEATURES  
ALL VEHICLES  
ISO-DIN unit  
provisions  
99-3301  
INSTRUCTIONS  
INSTALLA  
TION  
2
3
CD pocket holds  
(2) jewel cases  
APPLICATIONS  
"L"  
CAR  
PAGE  
BUICK  
Century 1997-2005........................................................ 1  
LeSabre 1995-2005...................................................... 1  
Park Avenue 1995-2005................................................ 1  
Regal 1995-2004.............................................................. 6  
Rendezvous 2002-2007................................................ 6  
CHEVROLET  
"R"  
KIT COMPONENTS  
Radio Housing  
Avalanche 2003-2006................................................. 6  
Cavalier 2000-2005....................................................... 6  
Express Van 2001-2007............................................... 5  
Impala 2000-2005......................................................... 5  
Malibu 2001-2003........................................................... 5  
Monte Carlo 2000-2005 ............................................. 5  
Trailblazer 2002-2007.................................................... 2  
Venture 2000-2005....................................................... 2  
GMC  
Slide Mounting Brackets ("L" and "R")  
into the slots on the sides of the Radio  
Housing as indicated.  
Slide the ISO-DIN head unit into the kit. Align  
the holes in the Mounting Brackets with the  
holes in the head unit and mount the Brackets  
to the head unit with the screws included with  
the unit.  
Envoy 2002-2007............................................................ 2  
OLDMOBILE  
Mounting  
Brackets  
4
5
A
Bravada 1998-2001......................................................... 2  
Silhouette 2000-2004................................................... 5  
PONTIAC  
B
C
Aztec 2001-2005.............................................................. 3  
Bonneville 2000-2005.................................................. 3  
Grand Am 2001-2005................................................... 4  
Montana 2000-2005..................................................... 4  
Sunfire 2000-2005........................................................ 4  
D
A) Strip wire ends back ½"  
B) Twist ends together  
C) Solder  
TOOLS REQUIRED  
WIRING AND ANTENNA CONNECTIONS (Sold Separately)  
Harness:  
D) Tape  
applications  
Antenna adapter: • 40-GM10 - GM antenna adapter 88-up  
Phillips screwdriver  
Socket wrench  
Re-connect the battery terminal and test the unit  
for proper operation. Mount the head unit/kit  
assembly to the sub-dash with those screws  
previously removed in step #1.  
Locate the factory wiring harness in the  
dash. Metra recommends using the  
proper mating adaptor and making  
connections as shown. (Isolate and  
individually tape off the ends of any  
unused wires to prevent electrical short  
circuit).  
KNOWLEDGE IS POWER  
Enhance your installation and fabrication skills  
by enrolling in the most recognized and respected  
mobile electronics school in our industry.  
or call 800-354-6782 for more information  
and take steps toward a better tomorrow.  
1-800-221-0932  
REV. 07-29-09  
© COPYRIGHT 2001-2009 METRA ELECTRONICS CORP.  
 
CHEVROLET Express Van 2001-2007  
CHEVROLET Trailblazer 2002-2007  
Disconnect the negative battery terminal to prevent an  
accidental short circuit. Remove (2) 10mm bolts from  
below knee bolster under steering column and remove  
panel. Remove (2) 10mm bolts from panel below  
passenger dash airbag and remove panel. Remove (2)  
10mm nuts from inside center pocket between power  
outlets. Unsnap and remove radio and instrument cluster  
panel. (May not be necessary to completely remove radio  
and instrument cluster panel to access radio.) Remove (3)  
9/32" bolts to remove radio.  
Disconnect the negative battery terminal to prevent  
1
1
1
an accidental short circuit. Remove (2) phillips  
screws inside climate cluster. Remove (1) phillips  
screw under climate controls to the left of the power  
outlet. Remove (2) 9/32" screws from under  
steering column, lower the panel to access (3)  
phillips screws from around steering wheel and  
remove. Unsnap and remove bezel. (Use caution  
pulling over hazard switch.)  
CHEVROLET Impala 2000-2005  
CHEVROLET Venture 2000-2005  
Disconnect the negative battery terminal to prevent an  
accidental short circuit. Open drivers door and remove  
fuse panel on end of dash. Open passenger door and  
remove panel on end of dash. Remove (1) Phillips screw  
from each side exposed. Remove (3) screws from top of  
glove box liner. Remove (2) screws from the top-left corner  
of the glove box cavity. Remove (1) Phillips screw from the  
defroster duct. Remove the duct work and (1) Phillips  
screw exposed. Remove the dash pad and (3) Phillips  
screws exposed at the top of the radio trim bezel. Skip to  
the Installation Instructions for ALL VEHICLES on Page  
#3.  
Disconnect the negative battery terminal to prevent  
anaccidental short circuit. Open cup holders and  
remove (2) phillips / 7mm screws. Unsnap and  
remove dual power outlet assembly from lower  
storage. Open lower storage door and remove (2)  
7 mm screws inside. Remove (2) 7mm screws  
(facing up) from under cup holder. Remove (3)  
7mm hex head screws and remove radio.  
1
GMC Envoy 2002-2007  
CHEVROLET Malibu 2001-2003  
Disconnect the negative battery terminal to prevent an  
accidental short circuit. Unsnap and remove radio  
bezel. Remove (3) bolts and remove radio.  
Disconnect the negative battery terminal to prevent  
an accidental short circuit. Remove the climate  
control knobs. Remove (1) phillips screw above  
and (2) phillips screws below the climate controls.  
Unclip the radio trim bezel. Remove (4) screws  
from the factory head unit, slide the unit out and  
disconnect the wiring.  
1
CHEVROLET Monte Carlo 2000-2005  
OLDSMOBILE Bravada 1998-2001  
Disconnect the negative battery terminal to prevent an  
accidental short circuit. Unclip the trim panel above the  
pedals. (It is not necessary to remove the panel, it can  
remain hanging.) Remove (2) 9/32" screws from the knee  
panel and unclip the panel. Unsnap the driver's side fuse  
panel cover and remove (1) 9/32" screw. Open the glove  
box and remove (1) 9/32" screw from the upper left corner.  
Remove (3) 9/32" screws securing the factory radio and  
disconnect the wiring.  
Disconnect the negative battery terminal to prevent an  
accidental short circuit. Unsnap top trim of floor console  
and slide back. Remove (4) phillips screws: (2) left and (2)  
right lower from the carpeted panel. Slide carpeted panel  
down and backwards to reveal (2) phillips screws and  
remove. Unsnap radio bezel and unplug cigarette lighter  
and accessories. Remove (3) 7mm screws and remove  
radio.  
1
1
5
2
 
OLDSMOBILE Silhouette 2000-2004  
PONTIAC Grand Am 2001-2005  
Disconnect the negative battery terminal to prevent  
Disconnect the negative battery terminal to prevent  
1
1
an  
accidental short circuit.Open cup holders and  
anaccidental short circuit. Unsnap and remove  
radio trim bezel. Remove (3) 9/32" screws from  
radio brackets and remove radio.  
remove (2) phillips 7mm screws. Unsnap and  
remove dual power outlet assembly from lower  
storage. Open lower storage door and remove (2)  
7mm screws inside. Remove (2) 7mm screws  
(facing up) from under cup holder. Remove (3)  
7mm hex head screws and remove radio.  
PONTIAC Aztec 2001-2005  
PONTIAC Montana 2000-2005  
Disconnect the negative battery terminal to prevent  
an accidental short circuit. Pull out cup holder  
inserts. Remove (1) phillips screw exposed inside  
bottom cup holder. Unsnap and remove shifter trim  
with cup holders. Remove (2) #15 torx at bottom  
of radio / climate bezel.  
Disconnect the negative battery terminal to prevent  
anaccidental short circuit. Open cup holders and  
remove (2) phillips 7mm screws. Unsnap and  
remove dual power outlet assembly from lower  
storage. Open lower storage door and remove (2)  
7mm screws inside.Remove (2) 7mm screws  
(facing up) from under cup holder. Remove (3)  
7mm hex-head screws and remove radio.  
1
1
PONTIAC Sunfire 2000-2005  
PONTIAC Bonneville 2000-2005  
Disconnect the negative battery terminal to prevent  
an accidental short circuit. Open the glove box and  
remove (2) Phillips screws exposed on the right  
edge of the radio trim bezel. Unclip the bezel and  
remove. Remove (2) 7mm hex-head screws  
securing the factory head unit and disconnect the  
wiring. Skip to the Installation Instructions for ALL  
VEHICLESonPage#3.  
Disconnect the negative battery terminal to  
prevent an accidental short circuit.Remove (2)  
1
1
screws from the instrument cluster.Unclip  
phillips  
the ignition trim and remove.Unclip the climate  
control / radio trim bezel and remove. Depress the  
spring clips on each side of the factory head  
unit and remove.  
3
4
 

LG Electronics Air Conditioner AS H076PB D M WL1 User Manual
Liebert Power Supply PSI XR User Manual
Life Fitness Treadmill TR95 User Manual
Linksys Network Router E 4200 User Manual
LOREX Technology Home Security System CVA6991 User Manual
Makita Portable Radio BMR100 User Manual
Maytag Ventilation Hood UXT5230AY User Manual
Maytag Washer Accessories MAH4000AWW User Manual
Melissa Styling Iron 635 089 User Manual
Metra Electronics Automobile Accessories 99 3304 User Manual